THE FREEDOM WINGS

Kaier Falcon is a high speed glider. It can reach 120 Km/h (~74 mph) using 2212KV motor and 3S battery on the 1200mm wingspan. The structures are reinforced with carbon tubes to handle high speed maneuvers. Covering film is applied to make transparent skin and give the bird a special looking.

previous arrownext arrow
Slider

IMPRESSIVE PERFORMANCE WITH SIMPLE EQUIPMENT

This bird is designed with good aerodynamic characteristics to fly. It's easy to get balanced at high speed and requires only 3 channels: throttle, aileron and elevator. The rudder function is also reserved in case you want a smoother flight. 2212KV motor and 1500mAh 3S battery are usually for trainer, but with the Falcon they are enough to make impressive performance.

DESIGNED FOR ALL SIZES OF 3D PRINTER

This bird is printable with quite small size printers. The minimum build volume requirement is 120x120x130mm. PLA is recommended for easy printing and non-toxic, the thinnest wall is 1mm so you don't have to care much about print settings and the sun heat.

EASY TO BUILD AND FLY

It takes about 45 hours to print for standard printer. You are instructed from printing to assembly with both document and video clips. The print settings are quite simple because there is no thin wall and no support needed. Using bolts and nuts to assembly will save you much of time in case of mishap or replacing parts.